|
DVD Ripper
Guide: How to rip DVD?
Step 1
Load your DVD movie in the DVD drive by clicking "Open
DVD" in the File menu or the "DVD" button in the main
interface. The DVD Rip software will automatically scan
your movie. In the File menu, you can also specify to
encode certain segment or chapter.
Step 2
Under the “Input” area, click on the “Index” drop down
list box to select the title you want to decode.
Step 3
Under the “Input” area, please click on the “Audio” drop
down list box to select the language for your movie.
Step 4
If you wish to encode a different camera angle, just
click on the “Angle” pull down list box, the default
value is recommended.
Step 5
Under the “Input” area, please click on the “Subtitle”
drop down list box to select the subtitle for your
movie.
Step 6
Click on the "Format" dropdown list in the Output area
to select an output format you want to encode, such as
AVI (DivX, YUV).
If you want to specify the output format setup, just
click “Output Settings…” in the Settings menu to set.
All advanced settings, you can find out the introduction
by click “Contents” in the Help menu.
Step 7
Now start selecting the aspect ratio in the "Zoom"
dropdown list in the Output area. Default is None(
Letter Box 4/3). None( Letter Box 4/3), Medium(4/3) and
Pan Scan(4/3) is to convert 16:9 to 4:3 while Full(16/9
or 4/3 input) is to keep the same ratio as the original
movie. You can use the playback option to test your
selection too.
Step 8
Enter the output folder in “Output Folder” box or click
the “Browse” button to select.
Step 9
If you want to save as specific file size, select
"Custom size" in the “Volume Size” dropdown list and
click the “Settings” button to set, the default is 5MB.
When selecting "Infinite", the output file will be one
file.
Step 10
Once you are satisfied with you choices, click the red
button to begin the ripping.
Please Note: During DVD ripping, don't run other large
program to avoid lowering ripping speed.
Buy
Now Only $35
Download Free Trial
|
